Safety; General Safety Notes; Intended Use - Trotec Speedy 360 Operating Manual

Safety

2 Safety
TO AVOID POSSIBLE HARM READ AND FOLLOW THESE INSTRUCTIONS.
The machine is built at the time of it's development and production according to applicable, established technical rules
and is considered to be safe to operate.
Dangers can be caused by the machine if the machine:
is operated by unqualified personnel,
•
the personnel have not been trained,
•
the machine is used improperly or not as intended,
•
or if the machine is used for other intended purposes.
•
This chapter provides an overview of all important safety aspects that are necessary for optimum protection of persons
and safe and trouble-free operation of the machine. Other chapters of this manual contain specific safety notes for the
avoidance and prevention of hazards.
2.1

General safety notes

2.1.1

Intended use

The machine described in this manual is used for cutting, engraving and marking materials using the soware
supplied.
For information about materials, see chapter
technical support team in your area.
The unit may only be operated, maintained, and repaired by persons familiar with the intended application and the
hazards inherent to the machine.
The machine and safety devices may only be operated in perfect condition and must comply with the requirements of
the EU Machinery Directive.
The machine may only be operated in conjunction with a suitable and effective exhaust system.
The machine may only be used while it is being supervised.
Intended use also means that anyone who is responsible for the installation, commissioning, operation, maintenance
and/or repair of the machine must have read and understood these instructions, and in particular, the "Safety" chapter.
The instructions in this manual must always be followed.
The rotary engraving attachment may only be operated with cylindrical objects.
12
"Materials list". Alternatively, contact your Trotec representative or our