Installation And Commissioning; Mounting The Work Piece In The Rotary Attachment - Trotec Speedy 360 Operating Manual

Operation
3. Select the job from the list and place it in the
marking field.
4. Start the engraving process.
8.9.3

Installation and commissioning

8.9.4

Mounting the work piece in the rotary attachment

1. Measure the diameter of the workpiece.
2. Adjust the height and angle of the system by loosening and fixing the levers.
64
1. The machine must be switched off.
Warning Dangerous electrical
voltage
If the rotary attachment is connected
during operation, the connections and the
electronics will be damaged. Such damage is
excluded from the warranty.
1. Place the rotary attachment on the base frame to the
ruler using the insertion handles.
2. Connect the device with the connecting cable via the
connector on the le side of the housing.