Light Barrier Focus - Trotec Speedy 100 flexx Operating Manual

Operation
Notice
Using a flexx lens the focus point differs depending on the laser source.
Note when focusing using a focus tool, the standard focus tool supplied with a flexx lens is always adjusted for a fiber
laser source. Therefore it must only be used in conjunction with a fiber laser source.
8.9.1

Light barrier focus

Notice
The light barrier autofocus is ideal for flat opaque materials of unknown thickness.
This autofocus option will not wok on transparent, rough or very thin material, which is thinner as the
ruler itself.
56
1. Select the lens type in the menu bar of the control soware.
2. Make sure that the lens that is installed in the laser head is selected.
3. At the same time, press the Away key + Down key to adjust the
height of the machining table so that it moves upwards.
4. Press the Up-button + Down-button simultaneously for the table to
move up.
5. As soon as the previously loaded material passes the light barriers,
the upward movement of the table stops, and the table moves to
the correct focus position.
Focusing is then complete, and you can start the laser processing.