What You Need To Do Before Using Your T1 Access Unit; Observing T1 Access Unit Leds - Paradyne 9161 User Manual

About the T1 Access Unit
Component
5-Slot Housing (T1 Access Mux only)
Redundant AC Power Supply
– 48 VDC Power Supply (T1 Access Mux only)
Mounting Brackets (T1 CSU/DSU Access Unit
only)

What You Need to Do Before Using Your T1 Access Unit

Observing T1 Access Unit LEDs

1-2
Function
Accommodates one T1 NAM and up to four APMs for T1 Access
Mux applications.
Provides a backup for the ac power.
Provides – 48 Vdc power for the 5-slot housing.
Enables the 2-slot housing to be mounted on a wall.
A minimum configuration consists of a T1 NAM in either of the housings.
Subscribe to T1 service.
Install the housing. Refer to either the 2-Slot Housing Installation Instructions
or the 5-Slot Housing Installation Instructions for more information.
If you are installing a . . .
2-Slot housing
5-Slot housing
Install the T1 NAM and any appropriate APMs into the housing.
If you are installing a . . .
T1 NAM
Sync Data APM
E&M Analog Voice APM
FXS Analog Voice APM
Configure your T1 access unit for your particular application. Refer to the
916x T1 CSU/DSU Access and T1 Access Mux, Technical Reference for
configuration information.
LEDs are located on the various cards used in your T1 access unit. These LEDs
enable you to view general system status information. See the installation
instructions that accompanied your T1 NAM and APMs for more information.
November 1996
Then refer to the . . .
2-Slot Housing Installation Instructions
5-Slot Housing Installation Instructions
Then refer to the . . .
9161 T1 NAM Installation Instructions
9109 Sync Data APM Installation Instructions
9109 E&M Analog Voice APM Installation
Instructions
9109 FXS Analog Voice APM Installation
Instructions
9161-A2-GB20-00