Smeg Tethys D60 User Manual page 68

Washer disinfector
Table of Contents

Advertisement

The set of installation accessories (seals and hose ties) is inside the chamber.
The appliance can be installed with its sides flush against those of the adjacent cabinets, taking care not to obstruct
the steam vent on the rear. The wall at the back should be in masonry or another waterproof material.
Also take care that the heat does not reach any electrical circuits or sockets behind the appliance.
The appliance has water intake and drain hoses which can be positioned leading to the right or left, depending on
installation requirements.
If ordered in the appropriate version, the appliance can be installed built under a worktop; installation must be carried
out by skilled staff.
LEVELLING
After positioning the appliance, screw the feet down or unscrew them to adjust its height and level with the aid of a
spirit level so that it will be perfectly horizontal (max angle tolerance allowed: 0.5 °, corresponding to a maximum
permissible difference in height between opposite corners of the appliance of about 5 mm).
Correct levelling will ensure that the appliance operates correctly.
WARNING
Any adjustments, maintenance, etc. must be performed with the device switched off and disconnected from power
sources.
LIFTING AND TRANSPORT
Before shipment from the factory, the base of the appliance is fixed to a pallet used for both lifting and transport.
When moving the appliance around, a forklift truck or pallet truck must be used.
CONNECTIONS ON THE BACK OF THE APPLIANCE
ID.
DESCRIPTION
A
Demi water intake hose
B
Mains water intake hose
C
Electricity supply cable
D
Steam condenser exhaust hose
E
Appliance drain hose
P1
Peristaltic pump P1 intake hose and P1 can detergent level sensor cable
P2
Peristaltic pump P2 intake hose and P2 can detergent level sensor cable
RS-232 port for PC or printer connection
Cables with connectors for correct connection are provided with the following accessories:
H
1. Optional printer
2. PC connection cable, for communication of data by means of TRACELOG software.
User Manual
Tethys D60, Tethys T60
fig. 42 – Diagram of connections on rear of appliance.
Tethys D60 - Tethys T60 - Tethys T45
Page 68 - 77

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tethys t60Tethys t45

Table of Contents