Table of Contents
Advertisement
10.2
PRODUCT DIMENSIONS - MEASUREMENTS IN MM
10.2.1 Tethys D60, Tethys T60
The appliance can be requested with top for built-in installation for special requirements.
In this case, the product is 30 mm shorter than the stated height.
VERSION
STANDARD
STANDARD + AQUASTOP
10.2.2 Tethys T45
The appliance can be requested with top for built-in installation for special requirements.
In this case, the product is 20 mm shorter than the stated height.
VERSION
STANDARD
10.3
POSITIONING THE APPLIANCE
IMPORTANT
The appliance must be positioned with its back near a wall (with a gap of at least 10 mm) and must be installed by an
authorised engineer.
The installer engineer is responsible for the correct operation of the appliance after installation and must also
provide the user with all information required for its correct use.
During installation, the protective film must be removed from the steel outer surfaces.
User Manual
fig. 41 – Product overall dimension diagram
A
B
600
600
600
600
A
B
620
600
Tethys D60 - Tethys T60 - Tethys T45
C
D
30
600
30
600
C
D
30
450
E
F
850
> 10
857
> 10
E
F
850
> 10
Page 67 - 77
Advertisement
Table of Contents
