If The Device Is To Be Out Of Use - Smeg GW1160 User Manual

Coarse conical filter
To remove the coarse filter, press the "tabs" of the filter and pull upwards (detail A, see the figure above). Clean the
filter and replace it.
Conical fine filter
This is located underneath the conical coarse filter (B) and should be checked and cleaned whenever the coarse filter
is inspected. Clean with a brush and hot water for effective removal of deposits.
External circular filter
To remove this filter:
 Hold of the "tabs" of the coarse conical filter and turn it anticlockwise (C).
 Without pressing the tabs, lift the entire unit (D).
When cleaning this filter, it is best also to clean the others.
Recommendations for correct maintenance

The filters should be cleaned under running water using a stiff brush.

It is essential to clean the filters carefully in accordance with the instructions given above: the appliance washer
will be unable to operate correctly if the filters are fouled.

Fit the filters back in place with care before starting a washing program.
8.2

IF THE DEVICE IS TO BE OUT OF USE

If the appliance is to be left unused for a long time, follow these recommendations.
The procedure is recommended for periods of 24 hours or more out of use.

Perform the PREWASH program 1 with the appliance empty.

If contaminated materials are processed: run program 15 (or a program with a thermal disinfection Td phase)
with no load in the appliance.

Disconnect the electricity supply.

Leave the door slightly open to prevent unpleasant odours from forming inside the washing chamber.

Turn off the water intake tap.
User Manual
fig. 43 – Draining filters in the chamber; dismantling procedure and detailed view.
GW1160 - GW4060 Series Page 60 - 75