Selecting The Washing Programme - Smeg Tethys D60 User Manual

5.5

SELECTING THE WASHING PROGRAMME

The device has an interface, with segment display and 10 LED-lit symbols, for user-device communications.
To run a program:
1. Close the door by shutting it against the appliance until the lock clicks shut. The buttons are only enabled
with the door closed.
2. If the appliance is off, switch it on by pressing the On/Off key (hold down for 2 seconds)
3. Use the Selection buttons to select the program.
4. Once the selection has been made, the Functions button can be used to scroll through the program
parameters.
5. Only for Tethys D60: If the program includes a drying phase, its duration can be adjusted using the Drying
Decrease and Drying Increase buttons.
6. Press the Start/Stop button to start the cycle (hold it down for 2 seconds).
7. Two beeps sound to indicate the start of the cycle.
8. Once the selected program has been successfully completed, the display shows End".
9. Interrupting the cycle: A cycle in progress can be interrupted by pressing the Start/Stop button.
If the program is stopped, it is no longer possible to restart the current cycle. After the interruption a reset
cycle is performed automatically to return the machine to the standby condition.
User Manual
fig. 10 – Standard procedure for starting a cycle.
1 Select the program using the Selection buttons.
2 Check the program parameters: Functions button.
3 Start the program: hold down the Start/Stop button.
Tethys D60 - Tethys T60 - Tethys T45 Page 21 - 77