Deleting "Delayed Start" - "No Demi" Settings; Reset Procedure - Smeg Tethys D60 User Manual

The disabling option can be activated before starting the selected program, and remains active
for only one cycle, at the end of which it is deactivated automatically.
When the disabling option is active, demineralised water is replaced with cold water in all the
phases where it would normally be used.

5.11.4 Deleting "Delayed start" - "No Demi" settings

To delete a setting:
1. return the parameter to zero (e.g. "dh:00" for delayed start, " dE" for demi water).
2. switch the device off and back on (the default value is restored: e.g. "dh:00").
3. open the door of the device (for "delayed start" only) once the cycle start command has been given.
5.12

RESET PROCEDURE

The RESET procedure performs water pump-out and intake cycles to return the device to
conditions of safety in the event of a malfunction.
A RESET cycle can and should be started if an alarm occurs.
The Reset cycle can also be started independently, regardless of whether or not an alarm is
present.
N.B.: the RESET procedure can only be started with the door CLOSED.
When an error occurs, generally the device manages the anomaly itself: in this case the alarm
code flashes on the display until the problem has been dealt with: no reset commands are
accepted during this time.
Any RESET forced by the user will not be accepted until the problem has been dealt with and the
alarm code on the display is "steady". Eg: If alarm "AF:84" (overheating during drying) occurs, the
device manages its status independently and does not allow a RESET to be performed until the
automatic process for dealing with the alarm has been completed.
User Manual
fig. 21 – Demi water disabling buttons.
To access the function: hold down the Functions + Door opening buttons together.
To select demi water disabling: Selection buttons
Tethys D60 - Tethys T60 - Tethys T45 Page 32 - 77