Smeg Tethys D60 User Manual page 20

When the LEDs listed below light up, the value shown on the display is a parameter of the
washing cycle in progress or being selected.
When the cycle has not yet started: pressing the functions button displays the cycle parameters.
When the operating cycle is in progress: pressing the functions button displays the value reached
by the parameter associated to the LED.
SYMBOL
A0, thermal disinfection
With cycle running: The LED is on when the digits in the middle of the screen show the A0 value
reached.
With appliance in standby: when the LED is on the digits in the middle of the screen show the A0
value associated to the cycle being selected.
Parameter calculation and display are only enabled if the cycle has a thermal disinfection phase with
temperature of at least 80°C.
Temperature
With cycle running: The LED lights up when the display shows the temperature in the chamber.
With drying in progress: The LED lights up when the display shows the temperature in the dryer
pipe (function introduced from firmware version 4.6.xx.yy).
With appliance in standby: the value on the display shows the max. temperature associated to the
cycle being selected.
Thermal disinfection
Identifies a cycle with thermal disinfection; the LED flashes when a thermal disinfection phase is in
progress.
Drying
Only for Tethys D60. The LED comes on to identify a cycle with drying phase, even during selection.
The LED flashes when the drying phase is in progress.
Remaining time
With cycle running: The LED lights up when the display shows the time remaining.
With appliance in standby: the value on the display shows the estimated time for performance of
the program.
fig. 9 – "Functions" button With the cycle in progress or being selected, pressing the Functions button displays the parameters of the wash cycle: A0
User Manual
2 - Symbols associated to a washing cycle parameter
value, Temperature and Time Remaining.
Tethys D60 - Tethys T60 - Tethys T45
MEANING
Page 20 - 77