Table of Contents
Advertisement
5.6.2 Dosage Selections, Cancellation
or Use of Powder Detergent
Liquid detergent cannot be selected in
some of the programs. Powder detergent
must be used in these cases. For more in-
formation, see Programme Table.
If powder detergent is to be used in pro-
grams where the detergent dosing system
is operating, desired amount of detergent is
put into the powder detergent compart-
ment. If the detergent compartment in the
middle is to be used, the automatic dosage
selection must be deactivated.
Machine measures the load and determ-
ines the right amount of detergent depend-
ing on the load amount and the selections
made previously. The detergent taken is
not visible while washing, it is taken directly
with water over the laundry.
If another liquid detergent with different
properties than the one in the liquid deter-
gent dosing tank is preferred to be used, li-
quid detergent with said different proper-
ties should be put in the powder detergent
compartment in the middle and the liquid
detergent dosage selection should be deac-
tivated.
Softener will be taken from the dosing sys-
tem.
Liquid detergent and softener dosing symbols become
active or inactive according to the program selected on
the screen.
First position on the display means liquid de-
tergent is active, softener is on. If the liquid de-
tergent and softener symbol is lit, it means
that liquid detergent and softener dosing is
active.
If the liquid detergent and softener symbols
are active on the screen; when you press the
Automatic Dosing key for the first time, the li-
quid detergent will turn on and the softener
will turn off. If the softener symbol is not lit, it
means that softener will not be used in the
rinsing step.
When you press the Automatic Dosing key for
the seconds time, the powder detergent and
the softener will turn on. If the liquid detergent
symbol is not lit, it means that it can be
washed with powder detergent.
When you press the Automatic Dosing key for
the third time, the powder detergent will turn
on and the softener will turn off. When you
press it for the fourth time, it will return to the
first position.
5.6.3 Detergent and/or Softener Run-
ning Out
When the detergent or the softener put in-
side the detergent drawer finishes, the
dosage symbol in the display flashes.
When this symbol flashes, it is necessary to
add the decreasing detergent or softener to
the dosing tank. The product will be able to
dose enough for 2-3 more cycles from the
first moment the symbol flashes.
5.6.4 Filling Detergent or Softener into
the Wrong Compartment
In case you fill the detergent or the softener
in the wrong compartment, see "Cleaning
the Detergent Drawer".
EN / 18
Advertisement
Chapters
Table of Contents
