Table of Contents
Advertisement
Cleaning the water intake filter
The water intake filter on the outlet of the tap must be cleaned from time to time; this should be done every
2 – 6 months, depending on the quantity of water used. Turn off the water supply tap, undo the cap marked
"A" in the diagram below, remove the filter inside and clean it under running water. Put the filter back in
place and carefully screw the cap back into position.
14.3
IF THE DEVICE IS TO BE OUT OF USE
If you intend to leave the device out of use, proceed as follows.
14.3.1 FOR A FEW HOURS
If the device is to be unused and unattended for a few hours (e.g. overnight), proceed as follows:
1. Disconnect the electricity supply at the main switch.
2. Turn off the water intake taps.
14.3.2 FOR 24 HOURS OR MORE
Periods of 24 hours or more out of use.
•
Disconnect the electricity supply at the main switch.
•
Turn off the water intake taps.
When restarted, the device prompts the user to perform an automatic washing and thermal
•
disinfection cycle. Confirm with the "confirm" button (P5).
14.3.3 FOR 10 DAYS OR MORE
Periods of 10 days or more out of use.
Flushing the detergent system:
•
•
Remove the detergent intake lines from the jerry cans and insert them into containers of warm
(approximately 30 °C) softened (preferably demineralised) water.
•
Put the caps firmly back on the jerry cans of detergent.
Run the "Service " program twice in succession with no load in the chamber.
•
Disconnect the power supply.
•
Turn off the water intake taps.
•
•
When restarted, the device prompts the user to perform an automatic washing and thermal
disinfection cycle. Confirm with the "confirm" button (P5).
User Manual
Fig. 2 – Water intake filter
193909105 rev.04
BPW1260 – BPW4260
Page 89 – 107
Advertisement
Table of Contents
