Servicing And Routine Check Time Intervals; Daily; Weekly - Smeg Tethys D60 User Manual


The appliance filters are not clogged.
3. If the items in the load for washing in general are not cleaned properly, make sure that:

The right amount of detergent has been added.

There is regenerating salt in the tank.

The instruments have been positioned correctly.

The program selected is suitable for the type and degree of dirt on the instruments.

All the filters are clean and correctly fitted.

The spray arm water outlet holes are not clogged.

Nothing is preventing the spray arms from turning.

Make sure that the salt tank cap is firmly closed.
4. If the items in the load fail to dry or are dull, make sure that:

Absolute filter condition: operating hours can be viewed as an appliance parameter (the default operating hours
are set for normal conditions of use; the drying filter's working life will be reduced by dirtier than average
environments).

There is neutralising agent in the container.

The neutralising agent dispenser is set correctly.

The detergent used is of good quality and has not lost its characteristics (e.g. owing to incorrect storage, pack left
open, etc.).

Make sure that the salt tank cap is firmly closed.
5. If the elements processed are streaked, stained, etc. make sure that:

The amount of neutralising agent dispensed is not excessive.
6. If there are visible traces of rust in the chamber:

The chamber is made of corrosion-proof steel, so any rust marks are due to external factors (pieces of rust from
the water pipes, etc.). Specific products for removal of these stains are commercially available.

Make sure that the detergent doses are correct. Some detergents can be more corrosive than others.

Make sure that the salt tank cap is firmly closed.
7. If the optional printer does not work:

Check that the accessory is fitted with suitable thermal paper.

Check that the device is connected properly (both electricity supply and data connection).
If the faults persist after the instructions given above have been followed, contact your nearest authorised service
centre.
9.6

SERVICING AND ROUTINE CHECK TIME INTERVALS

9.6.1

DAILY

1. Check the detergent and neutralising agent levels in the cans and fill up if necessary.
2. Check spray arm rotation and inspect the water outlet holes visually to check that they are clean.
9.6.2

WEEKLY

1. Clean the sump filters, following the instructions provided.
2. Run PROGRAM 6, or another program with a thermal disinfection phase, without instruments for processing
in the appliance, for precautionary cleaning/disinfection of the washing chamber.
User Manual Tethys D60 - Tethys T60 - Tethys T45 Page 63 - 77