Smeg Tethys D60 User Manual page 56

ALARM ID DESCRIPTION
Drainage problems when using a
AF:37
mixture of water.
A-:41 P1 detergent intake anomaly
A-:42 P2 detergent intake anomaly
A-:43 P3 detergent intake anomaly
Door opening detected with cycle
AF:54 in progress. Door interlock
microswitch malfunction.
Door locking device malfunction,
AF:56
automatic opening failure
Dryer heating failure (only for
AF:58
Tethys D60)
Dryer motor "cooling"
malfunction. Cooling is included at
the end of the drying phase to
AF:67
bring the load processed and the
heating elements to a safe
temperature. (only for Tethys D60)
A-:68 P1 jerry can empty
User Manual
The use of a mixture of water is an option adopted in special
cases to cool the water discharged into the drain.
Check:
1. The intake water temperature; if the water is not cold enough
(recommended T<25°C) there may be difficult in achieving the
target temperature.
2. Problems with drain; check that the hoses and drain
connections meet the specified requirements.
1. Check that the detergent intake nozzle is correctly positioned
in the can.
2. Check for detergent leaks (pools of detergent around the
device).
This code provides a warning; it is not an alarm which cuts out
the appliance. Operation of the device can be continued by
pressing the Start/Stop button.
Proceed as for AF:41
Proceed as for AF:41
1. Make sure the door is closed properly before starting a cycle.
2. Do not force the door open with a cycle in progress; always
use the buttons provided on the appliance to stop a cycle and
open the door.
3. Check there is nothing between the door and the appliance's
chamber preventing the door from closing properly.
3. Follow the DEFAULT PROCEDURE described above. If the
alarm does not disappear, follow the RESET PROCEDURE.
Always make sure the door is closed properly before starting a
cycle.
Try to open the appliance again by pressing the Door opening
button.
If necessary, release the door lock by hand as described in this
manual.
Follow the DEFAULT PROCEDURE described above. If the alarm
does not disappear, follow the RESET PROCEDURE.
For the user: follow the DEFAULT PROCEDURE described above.
If the alarm does not disappear, follow the RESET PROCEDURE.
For the user: follow the DEFAULT PROCEDURE described above.
If the alarm does not disappear, follow the RESET PROCEDURE.
Check that there is detergent in the jerry can or that the level
sensor is operating correctly.
This is a warning and not an alarm as such; the washing cycle can
be started with this message present (i.e. overriding the warning)
by pressing the Start/Stop button again (hold it down for 2
seconds).
Activated at the end of the cycle and when the user attempts to
start a new program. If two or more similar alarms (e.g. cans P1
and P2 empty), the Start/Stop button will have to be pressed
twice or more before the cycle can be started. (The device's
internal memory records the event but allows execution of the
cycle).
Tethys D60 - Tethys T60 - Tethys T45
USER ACTION
Page 56 - 77