Handicare Freecurve Technical Manual page 55

Blind holes (studs, etc.)
Liquid only.
Onto
Threads
Into
Hole
1. Clean all threads (bolt and hole) with a cleaner.
2. If necessary, spray all threads with LOCTITE® Primer. Allow to dry.
3. Squirt several drops of LOCTITE® Threadlocker 262™/ 263™ or 271™ down the sides of the
female threads.
Use LOCTITE® Threadlocker 277™ if stud is over 1" diameter.
NOTE:
4. Apply several drops of LOCTITE® Threadlocker 262™/ 263™ or 271™ onto stud threads.
5. Install studs.
6. Position cover, head, etc.
7. Apply drops of LOCTITE® Threadlocker 242®/ 243™ onto exposed threads.
8. Tighten nuts as required.*
* 243™ may be used in place of 242® and 263™ may be used in place of 262™. Their primerless
formulations eliminate the need for LOCTITE® Primer in most applications.
Adjustment screws
1. Adjust screw to proper setting.
2. Apply several drops of LOCTITE® Threadlocker 290™ at screw and body juncture.
3. Avoid touching bottle tip to metal.
If re-adjustment is difficult, apply heat to screw with soldering gun (500°F).
NOTE:
Apply Threadlocker Here
Technical manual
LOCTITE
THREADLOCKER
®
LOCTITE
THREADLOCKER
™ /
Plunger
®
/ ™
®
™ or ™
55