Handicare Freecurve Technical Manual page 32

Handicare Freecurve
Turn & Go
A special powered swivel chair is the turn & go. By operating the joystick or remote, the chair will swivel
automatically at the bottom of the stairs and the user will ride in a swivelled position. The chair can not
swivel towards the top fl oor upstairs, so a rail run out of 500 mm is always required.
A resistance of 340 Ω is installed parallel to the powered swivel actuator. The software on the printed
circuit shall recognize this resistance before the lift can ride. The resistance is measured if the actuator is
in its end position.
You can only measure this resistance if the wiring of the actuator is cut off from the printed circuit.
Schematics
Powered swivel
Swivel motor replacement Video Turn & Go
This chair is delivered until November 2021.
32