Handicare Freecurve Technical Manual page 54

Handicare Freecurve
Thru holes (bolts and nuts)
Liquid, semi-solids and dry-to-touch tape.
Apply Here
Not
Here
1. Clean all threads (bolt and nut) with a cleaner.
2. If necessary, spray all threads with LOCTITE® Primer. Allow to dry.
3. Select the proper strength LOCTITE® threadlocker.
4. Insert bolt into thru hole assembly.
5. Apply several drops of liquid threadlocker onto bolt at targeted, tightened nut engagement area
or, when using the stick product, completely fill the root of the threads at the area of
engagement.
6. Assemble and tighten nut as usual.
Blind holes (cap screws, etc.)
Liquid only.
Onto
Threads
1. Clean all threads (bolt and hole) with a cleaner.
2. If necessary, spray (bolt and hole) with LOCTITE® Primer. Allow 30 to 70 seconds to dry.
3. Select the proper strength LOCTITE® threadlocker.
4. Squirt several drops down the sides of the female threads.
5. Apply several drops to bolt.
6. Tighten as usual.
NOTE: Using LOCTITE® threadlockers will virtually eliminate stripped threads, in aluminum or
magnesium housings, caused by galvanic corrosion.
54
Onto
Threads