Stairlift Rides Sometimes Slowly At Some Positions; Stairlift Beeps 6 Times During Calibration - Handicare Freecurve Technical Manual

19 |

Stairlift rides sometimes slowly at some positions

1) Drive lift to calibration position
2) Enable chair calibration mode (for rotating the chair motor only)
3) Press 3 switches at the same time for at least 2 seconds
a. One bottom side cover switch (with the knee)
b. One top side cover switch (with a hand)
c. Joystick DOWN (with the other hand)
4) After 2 seconds you should hear 2 beeps to confirm
5) Finish calibration in the usual way
6) Drive lift downward a short distance (10 cm or so)
7) Drive back up to the top
8) Finished. The slow driving behavior must have disappeared now
Explanation: apparently sometimes this slow driving mode (it is for preventing tilt) is accidently enabled.
20 | Stairlift beeps 6 times after calibration
If the power pack beeps 6 times, check whether the seat support is indeed horizontal, the tilt switch is
in the horizontal position, or whether the tilt switch is faulty. After correction, the power pack must be
calibrated again.
82