Remotes - Handicare Freecurve Technical Manual

Handicare Freecurve
19 |

Remotes

Stairlift Status
The remote control unit's LED indicates the stairlift's status:
Operation
when using remote control
when using remote control
when using remote control
when using remote control
when using remote control
when not using remote control
when not using remote control
Linking of the remotes
Video of the linking of the
remotes
Unlinking of the remotes
The pushbuttons can be unlinked from the print in the event of an error in the programming of the push-
buttons or the need to replace the pushbuttons.
The datacard should be taken for 3 seconds from the cardreader. Until you hear a beep.
Take care: the lift is not disconnected from batteries or chargestation
38
Remotes are standard delivered with a lift, one for each charge/stopping point.
The remotes operate on 868 Mhz.
The remotes are used to transport a lift without a person.
Situation
stairlift in start-up phase (3 sec)
stairlift travelling
stairlift stopped at an active charging station
stairlift is stopped at the end stop and will not
depart until it is called in the correct direction
stairlift is out-of-order and can no longer depart
stairlift stopped at an active charging station
stairlift is stationary en route, i.e. not at a charging
station
Remotes
LED
LED remains off
LED turns on
LED turns off
LED remains off
LED flashes twice a second
LED off
LED flashes twice a second for 20 seconds
after operation has stopped, LED then turns off