Multimeter - Handicare Freecurve Technical Manual

Handicare Freecurve
25 |

Multimeter

A multimeter is an indispensable tool to measure voltage, current and resistance.
The circuits should be tested as follows:
•
Use the electrical diagram to see which circuit you need to test
•
Disconnect the lift from the power supply
•
Set the multimeter to the 'beep' or resistance test mode
•
Remove the correct connector from the printed circuit board
•
Push the measuring pins into the back of the connector
•
Check that you are testing between the correct connector pins/numbers
•
No beep or a high resistance indicates that the circuit is broken
If there is a short circuit with the frame, hold one of the measuring pins against the unit's earth pin of the
seat and push the other measuring pins into the back of the connector.
Nb. Make sure the lift is not positioned on a charging point during the tests!
Video how to use the multimeter
48
Multimeter