5.5.2
Discrete Teach Modes
Teaching two separate points creates a window around that range.
Background Teach—Teaching the same point twice (points within 100 mm of each other) sets the switch point 200 mm in
front of the taught point.
Object Teach—Teaching the same point twice (points within 100 mm of each other) sets the switch point 100 mm behind the
taught point.
Window Teach—Teaching the same point twice (points within 100 mm of each other) sets a window ±50 mm on either side of
the taught point, for a total window size of 100 mm.
5.5.3
Set the Sensitivity
Use Sensitivity Selection to set the signal strength threshold.
1.
Access Sensitivity Selection.
Triple-pulse the remote input.
2.
Select the desired signal threshold.
Action
Pulses
1
2
3
4
T
5
T
6
T
T
T
7
T
T
T
8
T
5.5.4
Set the Speed
Use Speed Selection to set the speed of the sensor.
1.
Access Speed Selection.
Four-pulse the remote input.
2.
Select the desired signal threshold.
February 12, 2024
Action
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
Action
© Banner Engineering Corp. All rights reserved.
Q90R R-GAGE® Radar Sensor Instruction Manual
T
T
T
The green power LED flashes slowly.
T
T
TEACH Mode
Signal Strength Threshold = 1
Signal Strength Threshold = 2
Signal Strength Threshold = 3
Signal Strength Threshold = 5
Signal Strength Threshold = 10
Signal Strength Threshold = 15
Signal Strength Threshold = 20
Signal Strength Threshold = 30
T
T
T
T
The green power LED flashes slowly.
T
T
T
Result
Result
The signal threshold is set and the
green power LED flashes equal to the
number of pluses, pauses, and then
flashes equal to the number of pulses
a second time. Then the sensor exits
remote teach and returns to run
mode.
Result
19