Dimensions; Beam Patterns - Banner R-GAGE Q90R Instruction Manual

6.3

Dimensions

All measurements are listed in millimeters [inches], unless noted otherwise.
84
[3.31]
42
[1.65]
6.4

Beam Patterns

The beam pattern of the radar sensor is dependent on the radar cross section (RCS) of the target.
The beam pattern graphs represent Standard Mode and are guides for representative object detection capabilities based on
different-sized radar cross sections and corresponding example real-world targets. Use the following charts as a starting
point in application setup. Note that applications vary.
•
Use the Beam Width versus Distance chart to understand where corresponding objects can be detected. Adjusting
the signal strength threshold also affects the beam pattern when the target is constant.
• Use the Beam Width versus Degrees chart to help determine how much the target can tilt from 90 degrees while still
maintaining detection.
Unless otherwise specified, the following beam patterns are shown with Signal Strength Threshold = 1.
February 12, 2024
39.4
[1.55]
89.1
[3.51]
4X M6 x 1 - 6H
8.5
[0.33]
© Banner Engineering Corp. All rights reserved.
Q90R R-GAGE® Radar Sensor Instruction Manual
7
[0.28]
104.0
66 [4.09]
[2.60]
25