Q90R R-GAGE® Radar Sensor Instruction Manual
Figure 5.
Dual Discrete Output
* Push-Pull output. User-configurable PNP/NPN setting.
** Pulse Frequency Modulation
NOTE: Banner recommends that the shield wire (quick-disconnect cordsets only) be connected to earth
ground or dc common. Shielded cordsets are recommended for all quick-disconnect models.
2.3
Mount the Device
1.
If a bracket is needed, mount the device onto the bracket.
2.
Mount the device (or the device and the bracket) to the machine or equipment at the desired location. Do not tighten
the mounting screws at this time.
3.
Check the device alignment.
4.
Tighten the mounting screws to secure the device (or the device and the bracket) in the aligned position.
6
bn (1)
+
10–30 V DC
bu (3)
–
bk (4)
Load
D1_Out/IO-Link
wh (2)
Load
D2_Out/**PFM
gy (5)
Input
© Banner Engineering Corp. All rights reserved.
Continued from page 5
Key:
1 = Brown
2 = White
3 = Blue
4 = Black
5 = Gray (Connect for use with remote input or
Banner Radar Configuration software)
2
3
1
4
5
February 12, 2024