Fcc Part 15 Class A For Intentional Radiators; Industry Canada Statement For Intentional Radiators - Banner R-GAGE Q90R Instruction Manual

Radar sensor
Table of Contents

Advertisement

Q90R R-GAGE® Radar Sensor Instruction Manual
Certifications
E224071
Banner Engineering BV
Park Lane, Culliganlaan 2F bus 3
1831 Diegem, BELGIUM
Turck Banner LTD Blenheim House
Blenheim Court
Wickford, Essex SS11 8YT
GREAT BRITAIN
Output Ratings
Analog Outputs:
· Current Output (Q90R....-.I.. models): 1 kΩ maximum load resistance at 24 V; maximum load resistance = [(Vcc - 4.5)/
0.02 Ω]
· Voltage Output (Q90R....-.U.. models): 2.5 kΩ minimum load resistance
· Current rating = 50 mA maximum each
IO-Link Push/Pull
PNP
NPN
PNP
NPN
6.1

FCC Part 15 Class A for Intentional Radiators

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
(Part 15.21) Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this
equipment.
6.2

Industry Canada Statement for Intentional Radiators

This device contains licence-exempt transmitters(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two conditions:
1.
This device may not cause interference.
2.
This device must accept any interference, including interference that may cause undesired operation of the device.
Cet appareil contient des émetteurs/récepteurs exemptés de licence conformes à la norme Innovation, Sciences, et Développement économique Canada.
L'exploitation est autorisée aux deux conditions suivantes:
1.
L'appareil ne doit pas produire de brouillage.
2.
L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
24
Black wire specifications per configuration
Output High
Output Low
Output High
Output Low
Output High
Output Low
White wire specifications per configuration
Output High
Output Low
Output High
Output Low
© Banner Engineering Corp. All rights reserved.
ETSI EN 305 550 V2.1.0
ETSI EN 305 550-1 V.1.2.1
ETSI EN 305 550-2 V.1.2.1
FCC ID: UE3Q90R
IC ID:7044A-Q90R-6
Install where not accessible by unauthorized personnel.
The device shall only be accessible for adjustment,
programming, or maintenance.
The device was evaluated for IK08 impact energy in
accordance with IEC 62262.
Advanced Capabilities
≥ Vsupply - 2.5 V
≤ 2.5 V
≥ Vsupply - 2.5 V
≤ 1V (loads ≤ 1 MegΩ)
≥ Vsupply - 2.5 V
≤ 2.5 V
≥ Vsupply - 2.5 V
≤ 2.5 V (loads ≤ 70 kΩ)
≥ Vsupply - 2.5 V
≤ 2.5 V
February 12, 2024

Advertisement

Table of Contents
loading

Table of Contents