Hardware Installation - Raise3D Forge1 User Manual

Raise3D Forge1 User Manual Hardware Installation
D.

Hardware Installation

1.
Locate the four shipping zip ties, and remove
them.
It is recommended to unclip these as opposed to
cutting them. They can be reused if you need to
transport your machine in the future.
3.
Select the largest of the included hex-head
wrenches (3mm), and remove all four hex head
security bolts from Z-axis clamps (2 bolts each).
These are located on the left and right sides of the
printer of the ball screw thread.
Remove
Remove
Hex Wrench
(× 2)
(3 mm)
2.
Peel off the yellow stickers and remove the 24
security spacers.
These clips are designed to hold the extruder
assembly in place during shipping, and should be
saved for future transport. Do not operate the
printer with the clips installed.
4.
Plug the machine into a wall outlet using the power
adapter for your designated country (5 included).
Flip the switch to power the unit on.
Remove
(× 24)
15