Raise3D Forge1 User Manual page 15

Raise3D Forge1 User Manual List of Parts
A. Top Cover
The upper cover of the printer. The filament can be placed here, which can accommodate 2 rolls of
3kg filaments at the same time.
B. Spool Holder
Filament holder with wheels to allow filament spool rolling free when feeding.
C. Filament Run-out Sensor
An automated optical detection system is adopted to detect whether the filaments are sufficient.
When the filaments are running out, the printer will automatically stop printing.
D. Door
Door to open filament box.
E. Holder Frame
The frame lifting weight of filament.
F. Filament Guide Tube
Protects and guides filaments.
G. Extruder
The part extruding filament to the hot end; brand-new unitized extruders, which are more convenient
to disassemble; a dual extrusion structure is adopted to adapt to a variety of filaments.
H. Fans
Used to cool the heat down.
I. Hot End
The part that melts filaments; with the quick-release design, even beginners can quickly remove
the hot end within one minute; it is more convenient to repair the hot end after removing it.
J. Touch Screen
To control the printer and check the status of the printer.
K. Print Bed
A plate for printing the model.
L. Metal Quick Connector
Can automatically lock inserted filament and release filament by push.
M. Camera
Used to observe the operation of the printer.
N. Flat Cable
The integrated cable that transmits the signal from the motion controller board to the extruder. A new
flat cable is adopted to replace the large drag chain of Pro2 series printers, reducing the weight of
the extruder and avoiding the sagging of the cross shaft.
O. USB Interface
2 USB2.0 interfaces.
13