Raise3D Forge1 User Manual page 21

Raise3D Forge1 User Manual Hardware Installation
After removing the starter box, keep following the start-up wizard to finish the network connection, printer
settings and RaiseCloud settings.
After the start-up wizard, the printer will carry out 5-steps Offset Calibration, and the whole process takes
about 1 hour.
Calibrating the offset value of the printer can increase the printing success rate. Offset Calibration
includes Left Z Probe Offset, Right Z Probe Offset, Bed Leveling, R-Nozzle XY Offset and Dual-Color
Cube. The calibration process also includes loading the filament. After all calibrations are completed by
following the instructions on Raisetouch, subsequent printing can be performed.
NOTE: Once all the basic settings are completed, a window introducing EVE will pop up. Please follow it
to move to the next step.
1.
2.
Adjust the distance between the left nozzle and
the build plate. If one corner of the bottom plate is
a few millimeters higher or lower than the other
corner, this gap can be compensated by
calibration.
Adjust the distance between the right nozzle and
the build plate.
19