Raise3D Forge1 User Manual page 29

Raise3D Forge1 User Manual Dual Extruder Printing-Loading
After loading both sides of extruders, press the
4.
"Utilities" tab on the bottom of the screen, and set
the temperature of the left nozzle to match the
requirements of the filament that you are using.
Press the "Load" button, and the printer will begin
to heat. When the target temperature is reached,
press "Load".
Complete the feeding operation according to the
instructions on the screen.
NOTE: This document's instructions are based on
the properties of Raise3D PLA filament. This is the
standard filament included with your product and
it is advised to use Raise3D PLA for testing and
initial setup.
27