Advertisement
Pro-Series
3D Printer
B
Hardware Installation
1
Recommend to unclip the Zipties as you
are able to reuse the ties later.
3
Use the 3mm hex wrench to remove the Z
axis clamps on both Z axis ball screws.
The 3mm hex wrench is packed inside the
tool box located inside the top foam.
/ Quick Start Guide
Remove!
Remove!
(×2)
Hex Wrench
(3 mm)
2
Please remove the 24 clips holding the
extruder assembly in place before power-
ing on your printer. If you fail to remove
these clips your printer will be damaged.
Please save these clips and re-install them
if you transport your printer.
4
Plug the machine into a wall outlet and
power on. The Power cable is packed
inside the tool box located inside the top
foam.
Remove!
(×24)
Advertisement
