Removing Prints - Raise3D Forge1 User Manual

Raise3D Forge1 User Manual Removing Prints
L.

Removing Prints

1.
> 10 cm
2.
3.
Make sure the printer is idle, and that there is at
least a 10 cm gap between the prints' top and the
nozzle.
Wait for the build plate and nozzles to cool down
to room temperature before removing any prints.
If you wish to remove prints before they have
sufficiently cooled down, wear the heat-resistant
gloves from the attached accessories.
Lift the build plate handle a little bit to detach the
build plate from the Z platform.
36