Raise3D Forge1 User Manual page 37

Raise3D Forge1 User Manual Dual Extruder Printing-Advanced Slicing
8.
You can specify a nozzle to print support structure under Support tab.
9.
ideaMaker is not able to detect when a floating model is being supported by the opposite extruder
and will prompt the user to add supports. The user should select not to add support structure as it
will not be needed.
10. You can select your extruder and platform structure choice in the "Platform
Additions" tab. These structures include: Raft, Brim, Skirt.
11. Wipe Wall
Enable Wipe Wall will add extra shell(s) around the model during dual-extruder printing. This
wall(s) can help clean the oozing filament from the unused nozzle to reduce the effects of excess
material on the final model.
Wipe Wall Offset refers to the distance between Wipe Wall and the outer shell of the model. If the
wall is positioned too closely, the Wipe Wall may stick onto the model. If the wall is set too far, the
wiping results may be affected.
Wipe Wall Angle refers to the maximum angle for generating the Wipe Wall. If the maximum angle
is set too low, the wall may have a difficult time obeying the shape of the model, especially around
curved surfaces.
Wipe Wall Loop Lines adjust the thickness of Wipe Wall.
Wipe Wall Type changes the shape of Wipe Wall. The difference among the following 3 types are
the distance between Wipe Wall and the model.
Contoured type will generate a Wipe Wall structure with almost the same shape of the outlines of
the model. In some cases, it will be too close to the model which may be difficult to remove
especially with inner structures.
Water Fall will attempt to follow along the horizontal model contour.
Vertical will create a vertical wall at the height of the model. It is ideal for simple structures like
tubes or cubes.
35