Raise3D Forge1 User Manual page 18

Raise3D Forge1 User Manual Hardware Installation
5.
(× 8)
Remove
Loose 8 screws on top of printer with 2.5mm hex
wrench.
7.
Place holder frame on top of printer with all 4
screw holes on each piece are aligned.
Tighten 4 M4x25 screws with 3mm hex wrench
through the screw holes to fix the holder frame on
printer.
Reinstall removed cover back to left panel with
original screws and 2.5 mm hex wrench.
Note: Find and pull out the ends of filaments run-
out sensor cable from bottom of holder frame right
panel during installation.
6.
(× 8)
Remove
Loose 8 screws on left panel of holder fame with
2.5mm hex wrench.
Take off the cover of left panel.
8.
Find the pairing socket out of the cover of Electric
Control System. Connect the two ends and the
socket. Hide the run-out senser cables on the
bottom of the printer.
16