Advertisement
N-Series
3D Printer
B
Hardware Installation
1
Recommend to unclip the Zipties as you
are able to reuse the ties later.
3
Use the 3mm hex wrench to remove the Z
axis clamps on both Z axis ball screws.
The 3mm hex wrench is packed under the
printing platform.
/ Quick Start Guide
Remove!
Remove!
(×2)
Hex Wrench
(3 mm)
2
Please remove the 24 clips holding the
extruder assembly in place before power-
ing on your printer. If you fail to remove
these clips your printer will be damaged.
Please save these clips and re-install them
if you transport your printer.
4
Gently lift the build plate gently with
your hands and remove the accessory bag
under the build plate and open it for
standby. You can gently turn the ball screw
by hand to raise the z platform to help taking
out the accessory bag.
Remove!
(×24)
Advertisement
