Advertisement
3. Entering the Drum
Part Loop
Recording
© Delete any wrong notes.
—
1 With the Recorder sil running, press the | EXIT/NO | button when you reach a
place where you think the timing is incorrect.
For as long as you continue to hold down the] EXIT/NO
jbutton. the recorded notes for
the displayed instrument will be deleted. If you're quick enough on the button, you can
use this for a "realtime edit" to get rid of just one or two bad notes.
Q-— 2 When
you've
deleted
the
offending
section,
put in new
notes
with
the
Í ENTER/YES ]button again.
* This delete feature only works in Loop Recording, and only on the percussion sound
currently shown in the display.
& li you're finished entering the notes for the currently selected percussion instrument over this
select another Drum sound.
CS 1 With the Recorder still running, press|
REC
| .
This puts you back in Recording Standby again (the "R" at the right of the screen will
flash), so that you can press the Tap Entry key ([ENTER/YES ] button) without
recording the sounds.
ran
Press [REG]to turn Tap Entry off
(flashing)
à
* Current Measure Number
(alternates between 1 and 2 in this case)
Change this with PARAMETER
[PREVIOUS
(see Drum Set («7r P. 9-15))
@— 2 white tapping on tne [ENTER/YES |button, press PARAMETE
This way you can check on the sounds as you scroll through to select the right one.
@—
3 when you find the one you want to record next, press[REC |.
Recording is underway again.
(—4 4 Repeat Steps @ through ® until you've finished the Drum Part over this looping
_Tange.
Straight o out of the box, the GR- [d zas the followi ing " different nt Drum sounds t 10 y choose from:
BD1,SD1, CHH. OHH, HT1. HT2, MT1. MT2, LT], LT2, CRI. CR2.
RID, SPL, SST, HCP, CWB.
t these sounds to select.
optional SR-GR-01 Expansion kit installed to actuall
BD2,5D2. PHH, RDB. CHN, TBR, MCG, HCG. LCG, HTL. LTL. HAG,
The following sounds are not in fact "stimdard equipment" on the GR - 1. You have to have the |
H
LAG, CBS, WDB.
|
© Stop the Recorder.
When you're nished entering Drum sounds over this Loop range. press the | START/STOP | button.
The metronome will stop and recordin:
s finished. The "Current Measure Number" will return to the
first bar of the Loop range (in this case. bar 1).
Advertisement
