General Notes - Benning ST 755+ Operating Manual

Introduction

1.2 General notes

1.2 General notes
Target group
This operating manual is intended for the following groups of people:
• Qualified electricians and electrotechnically trained personnel
Required basic knowledge
To understand these operating manual, you will need general knowledge of testing and
measuring equipment. Moreover, you will need basic knowledge of the following issues:
• General electrical engineering
Purpose of the operating manual
This operating manual describes the device and provides you information about how to handle
it.
Keep this operating manual in a safe place for later use. Read this operating manual before
handling the device and follow the instructions.
NOTE
Disclaimer of liability
Please make sure that any person using the device has read and understood the instructions of
this operating manual before handling the device and that the instructions are adhered to in all
points. Non-observance of this operating manual might result in product damage, property
damage and/or personal injury.
Benning assumes no liability for damage and malfunctions resulting from the failure to observe
the instructions in this operating manual.
The devices are subject to continuous further development. Benning reserves the right to make
changes to the device's design, configuration and technology. The information in this operating
manual corresponds to the state of technical knowledge at the time of printing. For this reason,
no claims for certain device characteristics can be derived from the contents of this operating
manual.
Information in this operating manual can be changed at any time without prior notice. Benning is
not obligated to make amendments to this operating manual or to keep it up to date.
Direct any technical questions to Technical Support [} page 12].
Figures and drawings
This operating manual includes figures and drawings for general illustrative purposes. The
functional possibilities and representations can deviate from the present device.
Test standards
The content of this operating manual is intended to describe the appliance tester and in no way
replaces the currently applicable test standards.
5284 / 08/2023 en BENNING ST 755+ / ST 760+ 11