Functional Test; Figure 22Functional Test (Connection Diagram, Circuit Diagram) - Benning ST 755+ Operating Manual

9.5.7

Functional test

The functional test [} page 45] is intended for the final verification of electrical safety.
Requirements
• Approved safety measuring lines
• Please observe the requirements for measuring [} page 71].
• The test sample is disconnected from the mains.
• Make sure that you are familiar with the procedure for manual [} page 77] and automatic
[} page 76] testing.
• Make sure that you know the necessary measuring points.
• The test sample has passed the safety test.
• The test sample is connected according to the connection diagram.
Figure 22: Functional test (connection diagram, circuit diagram)
1 Direct current measuring method (Class I, function)
2 Differential current measuring method (Class I, function)
Procedure
1. Start the test.
2. When testing a test sample of protection class II, use the test probe to scan all accessible
conductive components of the test sample for contact current testing. For leakage current
measurement, scan all active accessible and conductive components that are connected to
the housing.
Please observe inductive and capacitive circuits.
3. Change the polarity of the mains voltage at the test socket [} page 31].
4. Use the test probe again to scan all components.
Test the test sample in all switch positions (test sample functions), if available.
90
1
The shock-proof plug of the test sample is plugged into the test socket of the device.
The shock-proof plug of the test sample is plugged into the test socket of the device.
BENNING ST 755+ / ST 760+
2
Testing
9.5 Individual tests
5284 / 08/2023 en