Table of Contents
Advertisement
8
Configuration
8.1
Setting the system data
The "System settings" menu is intended to edit the basic settings of the device.
Menu
"Settings > System settings > System data"
Setting options
Parameter
Auto‑ID is enabled.
Auto-ID start
RPE test repetition
Test repetition
Notification sound
Short-circuit test
IT network
Mains pole reversal
Standard test procedures ON = Enables the standard test procedures.
Custom test procedures
Polarity testing extension
cable
56
Description
ON = The ID is automatically incremented [} page 33].
Start value that is incremented when a new customer is created or
a customer has no devices.
If test samples are already entered, the next free ID will be
determined automatically.
ON = During the protective conductor resistance measurement, the
device automatically detects whether a measuring point is
contacted with the test probe.
If the measured value is "OK", the device responds with an acoustic
signal and the next measuring point can be contacted.
If the connection is not OK, there will be two subsequent acoustic
signals.
ON = The device asks whether another measuring point shall be
contacted with the test probe.
The query applies to: R
off), R
, R
, R
Insu-2
Insu-3
Insu-4
ON = Switches on the acoustic signal of the device.
ON = Enables the short-circuit test before starting a measurement.
OFF = Disables the short-circuit test before starting a
measurement.
ON = Allows the device to be used in an IT network.
OFF = Disables mains pole reversal for leakage current
measurements.
OFF = Hides the standard test procedures when the custom test
procedures are enabled.
ON = Enables the custom test procedures.
OFF = Hides the custom test procedures when the standard test
procedures are enabled.
ON = Enables the polarity reversal test for extension cables.
BENNING ST 755+ / ST 760+
8.1 Setting the system data
(only if the R
test repetition is switched
PE
PE
, I
, I
, I
, I
Cont
Leak
PLeak
Cont weld.
Configuration
5284 / 08/2023 en
Advertisement
Table of Contents
