Introduction; Naming Convention - Benning ST 755+ Operating Manual

1

Introduction

The appliance tester BENNING ST 755+ / ST 760+ described here (in the following only
referred to as "device") is intended for the safety testing of electrical test samples (DUTs). The
basic versions of the device enable you to perform the following tests and measurements:
Standard
EN 50678
(VDE 0701)
EN 50699
(VDE 0702)
EN / IEC 62353
(VDE 0751‑1)
EN / IEC 60974‑4
(VDE 0544‑4)
Further information
https://tms.benning.de/st760plus-st755plus
On the Internet, you will find the following additional information directly at the specified link or
at www.benning.de (product search):
• Operating manual of the device in several languages
• Further information depending on the device (e. g. brochures, technical reports, FAQs)
1.1

Naming convention

Battery
In this operating manual, the term "battery" is used to refer to accumulators.
10
Measurement
Test procedure for electrical devices
after repair
Test procedure for electrical devices in
case of periodic testing
Periodic testing and tests after repair of
medical electrical devices or systems
Periodic inspection and testing of arc
welding equipment
BENNING ST 755+ / ST 760+
Introduction
1.1 Naming convention
ST 755+ ST 760+
X X
X X
X X
- X
5284 / 08/2023 en