Table 9 Operating The List View; Table 10 Status Messages - Benning ST 755+ Operating Manual

Operating options
Operation
Scrolling through lists
Selecting parameters
Selecting parameter
entries
Filling parameter
entries
Enabling and disabling
parameters
Table 9: Operating the list view
Status messages
The status displays the last parameter entry created or selected.
If no parameter entry is selected, one of the following status messages will be displayed:
Status message
"not selected"
"(empty)"
"(display all)"
"Connecting"
"Connected – waiting for IP"
"Connected"
Table 10: Status messages
30
Example Description
- Swipe up or down on the left half of the list view to scroll
through the list.
- Tap the parameter in the left half of the line to select it
(highlighted in blue). Further entries can be made using the
buttons in the footer.
Tap the right half of the line to open a selection window with
parameter entries (e. g. customer names, test sample
templates ...).
Tap the right half of the line to open an input window and
the soft keyboard for adding new entries.
Tap the slider to enable (ON) or disable (OFF) the
parameters. If the setting requires the authorisation of the
"Admin" user or is not possible due to another setting, the
slider is greyed out (light grey) in the given position and
cannot be changed.
BENNING ST 755+ / ST 760+
Description
The parameter has not yet been created or
selected.
If the department (empty) is selected, all the
test samples that are not assigned to any
department will be displayed.
If the department (display all) is selected, all
test samples will be displayed independently of
their assignment to a department.
A connection to the network is being
established.
The device is waiting for an IP address being
assigned by DHCP.
The device has been successfully connected
to the network and the connection is active.
General operation
6.5 Operating the list view
5284 / 08/2023 en