Change", "Copy" And "Delete" Using The Test Sample As An Example; Table 25 "Devices" Screen - Benning ST 755+ Operating Manual

Configuration
8.6 Managing a database
Parameter
Next test
No. of conductors
Line length (m)
Line cross-section
2
(mm )
P nom. (kW)
Private property
Note
Out of operation
Table 25: "Devices" screen
Use the "Test procedure" button to customise the test procedure of the test sample [} page 62].
Procedure – Selecting a test sample
1. To do this, tap the right of the "ID no." line.
An input window opens.
2. Enter the desired ID no. of the test sample or scan it using the barcode scanner or
RFID scanner.
3. Confirm your entries with the "Enter" button.
4. Confirm by tapping the "OK" button.
The selected test sample is displayed in the status message.
8.6.2.1 "Change", "Copy" and "Delete" using the test sample as an
example
Requirements
• A test sample entry already exists.
• A test sample entry is already selected.
Procedure – "Change"
1. Select the "ID no." line. To do this, tap the line on the left of the list.
2. Tap the "Change" button in the footer.
The "Device" screen is displayed.
3. Select the parameter (e. g. manufacturer) you want to change. To do this, tap the line on the
right.
An input window opens.
4. Enter the desired parameter entry or select one of the existing entries and confirm it with the
"Enter" button.
5. Save the change. To do this, tap the "Save" button.
The change of the test sample is stored in the database.
5284 / 08/2023 en
Description
The next test date is displayed.
Enter or select the parameter.
The test sample is private property. Use the ON/OFF slider to enable or
disable the setting.
Add additional comments on the test sample.
The test sample is out of operation. Use the ON/OFF slider to enable or
disable the setting.
BENNING ST 755+ / ST 760+ 67