Remotely Controlling The Device Using A Smartphone Or Tablet - Benning ST 755+ Operating Manual

Appendix
13.6 Remote control
13.6.2 Remotely controlling the device using a smartphone or
tablet
Requirements
• The "CerHost" app [} page 19] is installed on your end device (e. g. smartphone or tablet).
• The device is switched on and you are logged in as a user.
• DHCP is enabled on the device in the "WLAN-IPv4" settings.
• The following network information of the device is available:
– Host name
– IP address
Menu
"Settings > System settings > Network > WLAN-IPv4"
"Settings > System settings > Network > Remote control"
Procedure
1. Enable the WLAN hotspot on your end device.
2. Connect the device to your WLAN hotspot [} page 59].
3. Open the "CerHost" app on your end device.
4. Create a new "Device". To do this, tap the "+" symbol, enter the "Host name" and the
IP address of the device and save the information with the "SAVE" button.
5. Enable the remote control on the device. To do this, tap the "Remote control" button in the
network settings and confirm the "Warning" window displayed by tapping the "Yes" button.
6. Select the created "Device" and tap the "View" button.
The connection will be established automatically.
If the connection is not established, check your network settings as well as the access rights
of your WLAN hotspot.
5284 / 08/2023 en BENNING ST 755+ / ST 760+ 119