Establishing A Connection Via Wlan; Establishing A Connection Via Bluetooth - Benning ST 755+ Operating Manual

Configuration
8.3 Managing the network settings
8.3.1

Establishing a connection via WLAN

Menu
"Settings > Network > WLAN networks"
Procedure
1. Select a network.
If the desired network is not displayed, tap the "Update" button.
The signal strength of the WLAN network is specified in the corresponding line as a
percentage value (100 % correspond to full signal strength).
2. Tap the "Connect" button to connect the device to the network. The "Password" window
opens.
3. Enter your network password and confirm it with the "Enter" button.
Result
The device has been successfully connected to the network. The access data are now stored in
the device. When the status message "Not connected" is displayed, check if you are within
range of the WLAN network and if the password is correct.
To disconnect the network connection, select the network and tap the "Disconnect" button. To
delete the network connection, select the network and tap the "Delete" button.
8.3.2

Establishing a connection via Bluetooth

Requirements
• Bluetooth
Menu
"Settings > System settings > Bluetooth"
Procedure
1. Search for available Bluetooth
2. Select your device and tap "Connect".
If the connection fails, take the following corrective measures:
– "Disconnect" the Bluetooth
– "Delete" the Bluetooth
– "Search" again for the barcode scanner.
– "Connect" the barcode scanner again.
5284 / 08/2023 en
®
is enabled on the respective end device.
®
devices.
®
connection.
®
connection.
BENNING ST 755+ / ST 760+ 59