TVLogic LVM-074W Service Manual page 27

12.7 CABLIBRATION S/W INSTALLATION
3. Our calibration software supports the automatic detecting of the applied model
3. Our calibration software supports the automatic detecting of the applied model
connected for most of our monitors. However, monitors using the Genesis scaler
connected for most of our monitors.
(LVM-071W, LVM-091W, LVM-XX2W, FCM and LHM series) does not support this feature.
However, monitors using the Genesis scaler (LVM- 071W, LVM- 091W, LVM- XX2W, FCM
In this case, you must choose the applied model manually. Afterwards, click the
and LHM series) cannot afford this feature. In this case, you must choose the applied
model manually. Afterwards, click the "Re - Connect" button for re - connection.
"Re-Connect" button for re-connection.
4. If the measuring device is not detected, check and make sure that the "Measuring
4. If the measuring device is not detected, check and make sure that the "Measuring
Device" selection under the Setting menu is selected correctly.
Device" selection under the Setting menu is selected correctly.
5. Before starting the calibration, set the gamma and target luminance level in the
5. Before starting the calibration, set the gamma and target luminance level in the
Settings menu (See 3.Setting for more info).
Settings menu. (See 3.Setting for more info)
NOTE: To calibrate the XVM-245W using the K-10 probe, select the XVM cal file of K-10
NOTE: To calibrate the XVM- 245W using K- 10 probe, select the XVM cal file of K - 10
in the setting by pressing the "Set" button next to the measuring device selection.
in the setting by pressing "Set" button next to the measuring device selection.
6. Click the "Calibrate" button for the adjustment of the Gamma curve and color
temperatures.
6. Click the "Calibrate" button for the adjustment of the Gamma curve and color
temperatures.
Fig 4 Program Calibrating Monitor
27