Event Setup; Motion; Figure 17: Event - Motion Setup Screen - Eneo MPR-32R080200A User Manual

User's Manual

Event Setup

Motion

Your DVR has built-in video motion detection. Video motion detection can be turned On or Off for each camera.
You can define the area of the image where you want to detect motion; e.g., a doorway. Highlight the box under the
Zone heading, and press the
Press the button to display the menu screen. The menu on the setup screen has the following functions:
Select – Activates highlighted blocks to detect motion.
Clear – Deactivates highlighted blocks so that they will not detect motion.
Reverse – Activates inactive highlighted blocks and deactivates active highlighted blocks.
Select All Blocks – Activates all blocks to detect motion.
Clear All Blocks – Deactivates all blocks so that they will not detect motion.
Reverse All Blocks – Activates inactive blocks and deactivates active blocks.
Zone View – Displays any detected motion within the zone in red.
OK – Accepts changes and closes Zone setup.
Cancel – Exits Zone setup without saving changes.
32
Figure 17: Event – Motion setup screen.
Highlighting the box under the Sensitivity heading and pressing the
allows you to adjust the DVR's sensitivity to motion for Daytime and Nighttime
independently. There are five settings with 1 being the least sensitive and 5
being the most sensitive.
button. The Motion Zone screen displays.
The Motion Zone screen is laid over the video for the
selected camera. You can set up motion zones by
selecting or clearing blocks.
NOTE: You can set up motion zones one block at
a time in groups of 16 individual block groups. A
block group is positioned within the image area using
the Up and Down arrow buttons, and individual
blocks within the block groups are selected or cleared
using the camera buttons.
button