Table of Contents
Advertisement
Main Monitor
Highlight the box beside Mode and press the
Pressing the
button causes the DVR to sequence cameras, and the DVR can sequence cameras in two
SEQUENCE
modes: "Full" and "Cameo". In the Full mode, the DVR sequences through the cameras and displays them full screen.
In the Cameo mode, the bottom right window in a multi-screen format sequences through the cameras.
NOTE: Any cameras that are Off, have lost video or are set to Covert (unless the user has authority to view covert
cameras) will be excluded from the Cameo sequence.
You can define the screen layout in a variety of formats and set the DVR to sequence through the different screen layouts
(pages) so that all the cameras will be displayed. You can also set up the DVR to display one camera or a group of
cameras all the time while cycling through the remaining cameras in a "cameo" window. This can be done with one
camera displayed full screen while displaying the cameo window as a PIP (picture in picture), or displaying the cameras
in a grid pattern with the bottom right window as the cameo.
NOTE: Sequence cannot be used in the 4x4 display mode of the 16-channel and 4x3 mode of the 8-channel
DVR.
You can adjust the display dwell time by highlighting the box beside Interval and pressing the
select dwell intervals ranging from 1 second to 1 minute.
Highlight Event Monitoring On and press the
it is On, the DVR will display the camera associated with the event when an event occurs.
Highlight the box beside Resolution and press the
3840x2160 for NTSC video, and 1280x1024, 1440x900, 1920x1080 and 3840x2160 (@ 60Hz or 50Hz) for PAL
video.
NOTE: When the individual main monitors are connected to the HDMI and VGA connectors for simultaneous
operation, it is recommended to use monitors supported with the same resolution. If monitors unsupported
with the same resolution are connected, video cannot be displayed on the monitor with the resolution
you have set.
Highlight Set Resolution to Manual Mode and press the
regardless of the resolution supported by the monitor.
Highlight Fit To Screen and press the
On, the DVR will resize video to fit the main monitor screen.
Figure 41: Display – Main Monitor setup screen.
button. You can select between Full Sequence and Cameo Sequence.
button. Pressing the
button. You can select from 1280x1024, 1440x900, 1920x1080 and
button. Pressing the
button toggles between On and Off. When
button. When it is On, the resolution will be set manually
button toggles between On and Off. When it is
Digital Video Recorder
button. You can
59
Advertisement
Table of Contents
