Eneo MPR-32R080200A User Manual page 55

NOTE: The system restarts automatically after changing the port settings.
Do NOT use the same port number for two different programs, otherwise, the DVR cannot be connected
with the PC running RAS or WebGuard.
CAUTION: When changing the port settings, you must change the port settings on the PC running
RAS as well. Refer to the RAS manual for details.
Highlight Use UPnP and press the
the NAT (Network Address Translation) device to the DVR will be enabled automatically via UPnP (Universal Plug
and Play) service. This function will be especially useful when accessing a port on a private IP address.
NOTE: For the UPnP service to work, the NAT device should support the UPnP Port Forwarding function and
the function should be set to enabled.
You cannot change the port settings when Use UPnP is On.
Highlight the Status box and press the
service.
Highlight the Test box and press the
Selecting DHCP from the Type and highlighting Save button reads the current IP address of the DVR configured by
DHCP (Dynamic Host Configuration Protocol) network.
Highlight Auto (Default) and press the
the IP address of the DNS server automatically.
NOTE: Selecting Auto will only be enabled when the DVR is configured for DHCP network.
NOTE: If the DVR is configured for DHCP network, the IP address of the DVR might change whenever the unit is
turned on.
Change the numbers by highlighting them and using the Up and Down
arrow buttons to increase or decrease the number. The factory default
Port settings are:
Remote Admin:
Remote Callback: 8201
Remote Watch:
Remote Search:
button to toggle between On and Off. When it is On, port forwarding from
button to display the port numbers forwarded from the NAT device via UPnP
button to test the current LAN settings you made.
button to toggle between On and Off. When it is On, the DVR will obtain
Digital Video Recorder
8200
8016
10019
47