Eneo MPR-32R080200A User Manual page 42

User's Manual
Press the button to display the menu screen. The menu on the setup screen has the following functions:
Select – Activates highlighted blocks to detect motion.
Clear – Deactivates highlighted blocks so that they will not detect motion.
Reverse – Activates inactive highlighted blocks and deactivates active highlighted blocks.
Select All – Activates all blocks to detect motion.
Clear All – Deactivates all blocks so that they will not detect motion.
Reverse All – Activates inactive blocks and deactivates active blocks.
Zone View – Displays any detected motion within the zone in red.
OK – Accepts changes and closes Zone setup.
Cancel – Exits Zone setup without saving changes.
Turning Zone View On will allow you to observe how the DVR is reacting to motion. When in the motion viewing
mode, the detection zone of video will be displayed. Inward motion from outside the zone will be displayed in blue.
Highlight the box under the Actions and press the
each camera. Each camera can be associated with another camera, trigger an Alarm-Out connector, sound the DVR's
internal buzzer, notify a number of different devices, and/or move PTZ cameras to preset positions.
You can control excessive event logging and remote notification of Tripzone events detected after the Tripzone dwell
time by adjusting the Tripzone ignoring dwell intervals. Highlight the box beside Tripzone Ignoring Interval and
button. A list of intervals ranging from 1 to 10 seconds or Never appears. The DVR will not log and
press the
notify Tripzone events occurred during the preset interval range.
NOTE: The record action for motion events will not be affected by the Tripzone Ignoring function.
Highlighting Daytime Setup and pressing the
34
The Motion Zone screen is laid over the video for the
selected camera. You can set up motion zones by
selecting or clearing blocks.
NOTE: You can set up motion zones one block at
a time in groups of 16 individual block groups. A
block group is positioned within the image area using
the Up and Down arrow buttons, and individual
blocks within the block groups are selected or cleared
using the camera buttons.
button. The DVR can be set to react to motion differently for
button allows you to set up the Daytime range.
Highlight the box beside Daytime and press the
Up and Down arrow buttons to set the Daytime range. The DVR will
consider the remaining time range as the Nighttime.
button. Use the