Eneo MPR-32R080200A User Manual page 71

Sequence
Selecting (Sequence) in the Live Monitoring menu causes the cameras to display sequentially. It is the same as
pressing and holding the
SEQUENCE
will cause the DVR to go through predefined screen layouts (Full Sequence). Or, the bottom, right screen will display
live cameras sequentially (Cameo Sequence). For example, if you select
as follows:
Selecting again in the Live Monitoring menu exits the Sequence mode. While in the Sequence mode, the
displays in bottom-left corner if Sequence is selected in the Display setup screen (OSD tab). If all the cameras in a page
are Off, or have lost video or are set to Covert (unless the user has authority to view covert cameras), that page will be
excluded from the sequence.
NOTE: The Full Sequence for the full sequence monitoring and the Cameo Sequence for the cameo sequence
monitoring should be selected in the Display setup screen (Main Monitor tab).
Camera Menu
(Camera Menu) → PTZ and choosing the camera number allows you to control the selected
 PTZ: Selecting
camera as long as it has Pan, Tilt and Zoom capabilities. It is the same as pressing the
following PTZ Mode section for details.
(Camera Menu) → Zoom and choosing the camera number zooms the current image of the
 Zoom: Selecting
selected camera on the screen. It is the same as pressing the
Menu again exits the Zoom mode. Refer to the following Zoom Mode section for details.
(Camera Menu) → Audio toggles audio output On and Off.
 Audio: Selecting
 Color Control: Selecting
control brightness, contrast, hue and saturation for each camera for the selected camera if a user who has Color Control
authority logs into the system. It is the same as pressing and holding a camera button for a few seconds.
 Menu Control: Selecting
change camera settings supported in the camera. This is supported only when the camera uses Pelco-C protocol
and supports the UTC (Up The Coax) function.
 Edit Group: Selecting
pressing and holding the
Active Cameo Mode section for details.
NOTE: It is important that cameras and monitors are correctly installed and adjusted prior to making any image
adjustments using the DVR's controls.
Any image adjustments you make will be applied to both the live video on the monitors and the recorded
video.
The Camera Menu also can be displayed by clicking the right mouse button on the screen while in the
live monitoring mode.
button for three seconds or longer. When in one of the multi-view formats, selecting
< Full Sequence >
< Cameo Sequence >
(Camera Menu) → Color Control and choosing the camera number allows you to
(Camera Menu) → Menu Control and choosing the camera number allows you to
(Camera Menu) → Edit Group enters to the Active Cameo mode. It is the same as
button for three seconds or longer in any multiview formats. Refer to the following
MENU
in the 2x2 format, the DVR changes pages
PTZ
button. Selecting Zoom again in the Camera
ZOOM
Digital Video Recorder
icon
button. Refer to the
63