Registration Cordless Handset To Telephone Base - Oricom CARE920-1 User Manual

Registration Cordless Handset to Telephone Base

Registration Cordless Handset to Telephone
Base
Registration
Your handset and telephone base is pre-registered. If for some reason,
the handset is not registered to the base station, Put On BS will display on
the handset screen. Remove cordless handset off the charging base, if
disappears on the screen, register your handset according to the following
procedure.
1. Make sure the handset is off the charging base and shows Put On BS
before you begin registration.
2. Press and hold Page on the telephone base in idle mode for around 5
seconds until incoming call light LED bar illuminates on the telephone base.
3. Press on the cordless handset when idle.
4. Press or
5. Press or
flashes on the screen until registration is complete.
If registration fails, the telephone base screen displays Put On BS.
Pls. repeat the above procedure.
Locate the Cordless Handset
To locate the handset: On the base unit, press the PAGE softkey (button under
the word PAGE on the LCD screen) once.
All the handsets registered to the base unit will produce the paging tone and
"Paging" is displayed on the LCD of the handsets and on the base units
display.
You can stop the paging by pressing
base unit.
Note: If there is an incoming call during paging, the phone will ring with the
incoming call instead of paging.
to select HS Setting, then press
to select Register, then press Ok, Registered appears and
.
, on any handset or Page on the
,
32