Installation; Connecting The Telephone - Oricom CARE120 User Manual

Installation

Installing batteries in the phone
Warnings
You must install 4 AA batteries in the phone base. The battery
back up system will then be able to power the unit for up to 12
hours if there is a mains power failure.
If your mains power has been turned off for an extended period
or the power supply to the phone has been unplugged from
mains power you should replace the batteries with 4 new high
q uality AA batteries.
Before opening the battery compartment, make sure the
telephone is disconnected from the telephone line and the
mains power supply.
1. Use a flat-blade screwdriver or tip of a pen to lift and remove the
battery compartment door.
2. Insert four AA batteries into the compartment as indicated by the
polarity symbols.
3. Snap the battery compartment door back into place.
When this
replace the batteries. Always use 4 new high quality AA batteries.

Connecting the telephone

1. Plug one end of the telephone cable supplied into the TEL. LINE
jack at the back of the telephone base.
2. Plug the other end of the telephone cable into the wall outlet.
3. Plug one end of the curly cord into the socket on the handset.
4. Plug the other end of the curly cord into the left side of the
telephone.
symbol appears on the display or the display dims,
5